← Gas Tools

Onsite assistant

Ventilation requirements

Select the appliance and installation details to get the required free area and vent-position guidance.

Check before relying on the resultConfirm the appliance instructions and current technical guidance for the installation.
← Back to TomKat Gas Tools
NATURAL GAS VENTILATION
Natural gas only — domestic houses and flats. For open-flued, room-sealed and flueless appliances within the scope shown below.

A) Appliance Arrangement & Details

For natural-gas appliances in domestic houses and flats. Choose the appliance and installation details below. If the input is gross, the calculator converts it approximately to net using gross ÷ 1.11. Check the manufacturer’s instructions and current guidance before using the result.

Scope: associated gas appliances must total no more than 70 kW net. The automatic check covers only the heat inputs entered here. Check the complete associated installation separately, including any appliances whose input is not entered in this calculation.

For a single appliance, enter the appliance input. For multiple appliances of the same type, enter the total combined net input. For different appliance types, calculate each type separately and use the largest requirement.

B) Installation Details

For room installations, the assistant gives single-vent guidance where applicable. For compartments, high and low level ventilation is shown.

C) Site Conditions & Warnings

Answer the site questions that apply to this installation. Some answers produce a warning rather than change the calculated vent area.

For the open-flued air path, count the outside vent and the internal wall vents. Do not count the appliance compartment’s high and low vents.

← Back to TomKat Gas Tools

Using this resource

We take care to check our materials, but errors or omissions may still occur. This resource supports learning and practical calculations. It does not replace appropriate training, professional judgement, current standards or the appliance manufacturer’s instructions.

Check that the method and information apply to the installation you are working on. A calculated result or worked example does not establish that an installation is safe or compliant.

If you spot an error or an unexpected result, please contact TomKat so we can investigate. Your statutory rights are unaffected.

Contact TomKat: info@tom-kat.co.uk

Disclaimer:
This tool is provided as guidance only and is intended to support domestic natural-gas appliance ventilation training and calculation checks. It does not replace formal training, manufacturer instructions, current standards, site-specific assessment, or professional judgement. Results must be interpreted by a competent person in line with current guidance and safe working practices. No liability is accepted for any loss, damage or incorrect use arising from reliance on this tool.

Copyright © TomKat Gas Training Ltd. All rights reserved. This tool may not be copied, reproduced or distributed without permission.